A.3 Single Tests With Md 9273 Adapter; Appendix B P - Online Power Measurement - Kometec MD 9273 Bedienungsanleitung

MD 9273 Leakage Clamp
• Editing graphs of recordings
• Use Master instrument Workspace manager and Memory organizer
NOTE:
Look for the Voltage monitor
9273 Adapter tests and Master instrument-originated tests. When the Master instrument tests are selected
the voltage monitor is always present. When adapter tests are selected, it is omitted.

A.3 Single Tests with MD 9273 Adapter

This section describes the intended measurements and recordings supported by MD 9273 when used as a
test adapter. The set of tests may differ for different Metrel Master instrument.
Appendix B P – Online power measurement
Measurement parameters
There are no parameters to be set.
Connection diagram
Use Power test connection scheme from MD 9273 Manual.
Measurement procedure
• Connect MD 9273 to the item to be tested and set Bluetooth
• Enter the Power function and wait for active Bluetooth
• Start the continuous measurement.
• Stop the measurement.
• Save results (optional).
at the bottom right of the Single test screen to distinguish between MD
Figure B.4: Power test menu
32
P – Online power measurement
mode.
®
communication sign.
®