Velleman VTHD09 Bedienungsanleitung Seite 9

5.1 Useful Hints and Tips
•
The tool will become warm after prolonged use and must be switched off to cool it
down.
•
To ensure smooth running, periodically oil the shaft.
•
Do not apply too much radial pressure to the accessory bits while polishing,
cleaning, sanding or grinding. By doing this, you will put strain on the shaft and
adversely affect the precision of the tool. Always work with a sensitive touch so as
not to impede the efficiency of the tool.
•
When drilling in metal, always mark the drilling point with a centre punch so that
the drill will not slip.
•
Always ensure that you have maximum contact between the accessory shaft and
the collet.
5.2 Start-Up
Never start up the tool if the accessory is in contact with the piece to be worked on.
Hold it firmly and press the on-off switch. The tool will run continuously until the on-off
switch is flicked to the off position. Adjust the speed while the tool is running.
5.3 Speed Adjustment
This tool is equipped with a speed control. The speed switch is located on the rear of the
tool. Turn it slightly to increase or decrease the speed.
5.4 Mounting Accessories
Always remove the plug from the mains prior to assembly. Hold the collet lock button
while unscrewing the collet nut and screw the accessory in place. Hold the collet lock
button while you are fastening the collet nut. Do not operate the collet lock button while
the device is still connected with the mains.
5.5 Mounting the Flexible Driver
Remove the housing cap and the collet nut. Partially extract the internal transmission
cable from the flexible driver, insert the cable into the collet and screw the driver onto
the tool. Keep the shaft lock button pressed as you do it.
5.6 Mounting Accessories on the Flexible Driver
All accessories can be mounted onto the flexible driver. Follow the same general
procedure for mounting accessories on the tool.
5.7 Using a Support (not incl.)
It is advisable to use a bench support when using the flexible driver. Also, make sure to
fix the tool to the bench support using an appropriate fixing ring.
V. 04 – 22/11/2022
VTHD09
9 ©Velleman Group nv