General Guidelines - Velleman VTHD09 Bedienungsanleitung

3.

General Guidelines

•
Refer to the Velleman
manual.
•
All modifications of the device are forbidden for safety reasons. Damage caused by
user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
•
Nor Velleman Group nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising
from the possession, use or failure of this product.
•
Keep this manual for future reference.
4. Overview
1
2
5. Operation
This tool can be used for drilling, sanding and polishing, as well as engraving, cutting
and removing rust in tight spaces. The tool can be used on most metals, glass, wood
and ceramics. For best performance and results, keep the speed as even as possible
without exercising too much pressure. As a guideline, use the tool at low speed for all
large accessories, such as polishing, and at high speed for smaller accessories, such as
those used for engraving. For grinding and engraving, hold the tool as if it were a pen.
V. 04 – 22/11/2022
®
collet nut
collet
VTHD09
Service and Quality Warranty on the last pages of this
8
housing cap
3
shaft lock button
4
©Velleman Group nv