Rear View - MACHEREY-NAGEL NANOCOLOR VIS II Bedienungsanleitung

Hazard due to laser radiation: The barcode scanner of the NANOCOLOR
spectrophotometer is subject to laser protection class 1M. Do not look directly into
the beam of light from the barcode reader.
LASER RADIATION
DO NOT LOOK AT DIRECTLY
WITH OPTICAL INSTRUMENTS
LASER CLASS 1M

Rear view

A B C D
Fig. 1: Rear view
G H B C
Fig. 2: Rear view VIS II
A USB A connection
B USB B connection
C Ethernet (LAN) interface
D RS 232 interface
E Power connection 110 / 230 V
(~ 50 / 60 Hz)
For the VIS II spectrophotometer, only the associated mains adapter GTM96600‑6012‑R2
(REF 919156) may be used.
The on/off switch of the NANOCOLOR
on the back of the device. Switch the device on. After it is switched on, a start screen showing
the manufacturer's logo appears. The device performs a function test lasting approx. 1 minute.
Quickstart Guide NANOCOLOR
8
The NANOCOLOR
110 / 230 V (~ 50 / 60 Hz). Insert the power plug into
the power connection (Fig. 1 E ) on the back of the
device.
E F
/ II
UV
VIS
The NANOCOLOR
(min. 3.5A). Insert the corresponding power adapter
on the mains adapter and then connect the power
supply unit to the power connection (Fig. 2 E ) on the
D H F
back of the device.
Insert the power plug into an outlet.
F On/Off switch
G SDHC card slot (
H Power connection 12 V DC 3.5A
® UV
NOTICE
® UV
VIS II requires voltage of 12V
®
UV
cover; see the operating instructions Fig. 1d)
NOTICE
/ II (Fig. 1 F ) / NANOCOLOR
VIS
/ II / VIS II V 2.00/09‑2022
® UV
VIS
®
/ II requires voltage of
VIS
/ II underneath the lamp
VIS
VIS II (Fig. 2 F ) is
®