Aligning The Projector; Aligning The Projector Head; Adjus�Ng The Focus Of The Mo�F - Derksen PHOS 15 LT Nutzungsinformation

WARNING! Risk of burns!
You can burn yourself on projector parts which have become hot.
▶ Let the device cool for at least 10 minutes before any set-up work.
WARNING! Op�cal radia�on hazard!
Op�cal radia�on can cause temporary or permanent eye damage.
▶ Never stare directly into the beam of light.
• Switch on the projector

5.2. Aligning the projector

• Turn the projector into the desired posi�on.
(Note: There is a mechanical stop to limit the rota�on of
the device stand and prevent damage to the cable.)

5.3. Aligning the projector head

1. Loosen the countersunk screw.
2. Tilt the projector head into the desired posi�on. (Note:
There is a mechanical stop to limit the projector head's
rota�on and prevent damage to the cable. Do not �lt
or rotate the projector head without previously loosen-
ing the countersunk screw.)
3. Tighten the countersunk screw.
5.4. Adjus�ng the focus of the mo�f
1. Loosen the knurled screw.
2. Reposi�on the projec�on lens within the case un�l the
mo�f is in focus.
3. Tighten the knurled screw.
PHOS 15 LT
Se�ngs
27 / 48