Harvia Xenio CX1104XW01 Bedienungsanleitung Seite 21

INSTRUCTIONS FOR USE AND BATHING
• Always check that there are no objects on the heater or near the heater before switching it on.
• Beware of hot heater. The stones and metal parts of the heater may burn the skin.
• Sea air and a humid climate may corrode the metal surfaces of the device.
• Do not hang clothes to dry in the sauna, as this may cause a risk of fire. Excessive moisture
content may also cause damage to the electrical equipment.
• Do not press the overheating protection button before the cause of the fault has been found.
Only persons authorised to carry out electrical installations can reset the overheat protector,
unless otherwise stated in the instructions manual.
• Always check that the heater has switched off and stopped heating after the on-time period has
elapsed.
• The sauna room and surroundings of the heater must always be checked before the heater is
switched on again or it is switched on with the remote-control system.
• The sauna room and surroundings of the heater must always be checked before the device is
brought into standby mode required by remote control or pre-timed operation.
• According to the product standard IEC/EN 60335 -2-53 regulating electrical sauna heaters, the
control unit can be used to remotely control the heater once the heater or sauna room door is
equipped with a secure switch (safety or door switch).
Do not cover!
EN
21