Trouble-Shooting And Service - clage CFX-U Gebrauchsanleitung

GB
6
Repairs must only be carried out by
authorised professionals.
If a fault in your appliance cannot be
rectified with the aid of this table,
please contact the service organis-
tion of your importer or the Central
Customer Service Department at
CLAGE. Please have the details of
the typeplate at hand.
CLAGE GmbH
Central Customer Service
Pirolweg 1–5
21337 Lüneburg
Tel.: (+49) 4131 89 01-40
Fax: (+49) 4131 89 01-41
E-Mail: service@clage.de
CFX-U-GA-10_Sprachen-02-2010.indd 13

Trouble-shooting and service

Your instantaneous water heater CFX-U was manufactured conscientiously and checked
several times before delivery. Should malfunctions nevertheless occur, it is usually only
due to a bagatelle. First attempt to switch the house fuses off and on again in order to
reset the electronics. Next, try to remedy the problem with reference to the following
table. In doing so, you will avoid unnecessary expense of customer service assistance.
Problem
Water stays cold
Display flashes error message
"Er"
Flow rate of hot water too
weak
Selected temperature is not
reached , "MAX" lights
Selected temp. is not
reached , "MAX" does not
light
Symbol "sun" flashes
Appliance heats, the display
does not light
Remote control display: value
is incorrect
Symbol "battery" lights
Display: "no" and appliance
does not response to the
remote control
Display:"no" and radio
symbol flashes
Display: " - -" and radio
symbol flashes
13
Cause Solution
Master fuse tripped Renew or activate fuse
Reset STDB by customer
STDB tripped
service
Switch fuse off and on. If
Control system has
"Er" still flashes contact
switched off
customer service
Outlet fitting dirty or Clean shower head, jet
calcified regulator or sieves
Fine filter dirty or Let clean fine filter by a
calcified specialist
Water flow rate too Reduce water flow rate at
high the tap
Cold water has been Tap hot water only; set
added via the tap temperature for use
Inlet temperature
exceeding nominal Reduce inlet temperature
temperature
No radio contact Press key and repeat login
Flat batteries Replace batteries
Standby mode of the Press a key on the remote
remote control control
Insert two new type AAA
Flat batteries
batteries
Place the remote control
Range exceeded closer to the appliance,
register again
Range of the radio Disturbance through other
signal exceeded radio emitters
Hold the remote control in
Registration in process
front of the water heater
24.02.2010 16:24:32 Uhr