Air Filter - Husqvarna KLIPPO LB 448S Bedienungsanweisung

2. Remove the oil tank cap.
3. Drain the engine oil.
a) For models with an oil drain plug: Put a container
below the oil drain plug, to collect the engine oil
in.
b) For models without an oil drain plug or if it is not
possible to put a container below the oil drain
plug: Use an oil pump (accessory) to drain the
engine oil from the oil tank.
4. Fill with new engine oil of the type recommended in
Technical data on page 17 .
5. Do a check of the oil level. Refer to
the oil level on page 15 .

Air filter

Note:
An air filter that is used for a long time
cannot be fully cleaned. Replace the air filter at regular
intervals. Always replace a damaged air filter.
To remove and install the air filter (KLIPPO
LB 488SQ, KLIPPO LB 453SQ, KLIPPO LB
548Qe)
WARNING:
1. Push the clips on the air filter cover.
2. Carefully remove the air filter cover (A) from the
engine.
3. Remove the air filter (B) and the foam filter (C). (Fig.
44)
4. Examine the air filter for damages. Replace a
damaged air filter.
5. Clean and examine the air filter. Refer to
the air filter (KLIPPO LB 448SQ, KLIPPO LB 453SQ,
KLIPPO LB 548Qe) on page 16 .
6. Install in the opposite sequence.
To clean the air filter (KLIPPO LB 448SQ,
KLIPPO LB 453SQ, KLIPPO LB 548Qe)
CAUTION:
without an air filter attached or if the air filter
is dirty.
CAUTION:
cannot be fully cleaned or if it is damaged.
A defective air filter causes damage to the
engine.
1. Push the latch tabs (A), remove the air filter cover
(B) and remove the air filter (C). (Fig. 45)
16
To do a check of
Use protective gloves.
To clean
Do not operate the engine
Replace the air filter if it
2. Hit the air filter against a hard surface or blow
compressed air through the air filter from the clean
side of the air filter.
CAUTION:
remove dirt as this pushes the dirt into
the air filter.
3. Clean the air filter holder (D) and the air filter cover
with a moist cloth.
CAUTION:
goes into the air duct (E).
4. Install the air filter. Make sure that the air filter fully
seals against the air filter holder.
5. Install the air filter cover with the bottom tabs first.
To clean the air filter (KLIPPO LB 448S,
KLIPPO LB 453S)
CAUTION:
without an air filter attached or if the air filter
is dirty.
CAUTION:
cannot be fully cleaned or if it is damaged.
A defective air filter causes damage to the
engine.
1. Push the latch tabs (A), remove the air filter cover
(B) and remove the air filter (C). (Fig. 46)
2. Hit the air filter against a hard surface or blow
compressed air through the air filter from the clean
side of the air filter.
CAUTION:
remove dirt as this pushes the dirt into
the air filter.
3. Clean the air filter holder (D) and the air filter cover
with a moist cloth.
CAUTION:
goes into the air duct (E).
4. Install the air filter. Make sure that the air filter fully
seals against the air filter holder.
5. Install the air filter cover with the bottom tabs first.
To examine the spark plug
CAUTION:
recommended spark plug type. Incorrect
spark plug type can cause damage to the
product.
Do not use a brush to
Make sure that no dirt
Do not operate the engine
Replace the air filter if it
Do not use a brush to
Make sure that no dirt
Always use the
1912 - 002 - 13.10.2022