Maintenance; Maintenance Schedule - Husqvarna KLIPPO LB 448S Bedienungsanweisung

To set the cutting height
The cutting height can be adjusted in 6 levels.
1. Move the cutting height lever forward to increase the
cutting height.
2. Move the cutting height lever rearward to decrease
the cutting height.
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.
To start the product
1. Make sure that the ignition cable is connected to the
spark plug.
2. Open the fuel valve. (Fig. 23)
3. Stay behind the product.
4. Hold the engine brake handle against the handlebar.
(Fig. 24)
5. Hold the starter rope handle with your right hand.
6. Slowly pull out the starter rope until you feel some
resistance.
7. Pull with force to start the engine.
WARNING:
rope around your hand.
CAUTION:
rope fully. Do not release the starter rope
handle when the starter rope is extended.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.

Maintenance

Do a general inspection
Examine the oil level
Clean the product
Clean the air filter
1912 - 002 - 13.10.2022
Do not set the cutting height
Do not twist the starter
Do not extend the starter
Maintenance
Before you do
To use the drive on the wheels
• Push the drive lever down. (Fig. 25)
• Before you pull the product rearward, disengage the
drive and push the product forward approximately
10cm.
• Release the engine brake handle a small distance to
disengage the drive, for example when you go near
an obstacle.
To stop the product
• To stop the drive only, release the engine brake
handle a small distance.
• To stop the engine, release the engine brake handle
fully.
• Close the fuel valve. (Fig. 26)
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
• Keep the cutting cover clean. Buildup from grass
and dirt on the inner side of the cutting cover can
decrease the cutting result. Refer to
product externally on page 14 .
For more detailed information, refer to
www.husqvarna.com.

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 10 .
Daily
X
X
X
X
To clean the
Weekly Monthly
13