Husqvarna LB 548i Bedienungsanweisung Seite 19

To install the sensor
1. Make sure that the sensor is connected to the
Husqvarna Fleet Services
pairing operation between the app and the product
on page 18 .
2. Drill 2 holes by the marks in the enclosure slot.
Note:
Make sure that the holes are the same
dimension as the rivets supplied with the sensor.
3. Use a pair of pliers to remove the outer holes on the
sensor slot.
4. Drill 2 holes by the marks in the sensor slot.
1630 - 004 -
™ To do a
app. Refer to
5. Align the sensor slot with the enclosure slot.
6. Attach the sensor slot with the rivets.
7. Install the sensor in the sensor slot. Align the white
mark on the sensor with the mark on the sensor slot.
8. Close the lid to the sensor and lock it with the sensor
key. Make sure that the top of the Husqvarna "H"
points away from the safety key.
19