Appliance Handover; Environment And Recycling - STIEBEL ELTRON FEB Bedienung Und Installation

INSTALLATION | GUARANTEE | ENVIRONMENT AND RECYCLING
Commissioning
f Route a 4-core bus cable from the ventilation unit to the
mounting position of the programming unit. Use a screened
electronic cable such as LiYCY 2x2x0.8 mm². Do not route the
cable parallel to a three-phase cable.
The BUS cable must protrude 20 to 30 cm out of the wall to allow
installation.
Installation with a flush box
For securing to a wall we recommend using a flush box, which can
hold the part of the bus cable protruding from the wall.
f Make sure that the screws supporting the flush box are ar-
ranged either vertically or horizontally opposite one another.
f Route the bus cable through the aperture in the wall mount-
ed enclosure from the back.
Installation without a flush box
f To secure the wall mounted enclosure, drill four holes
(Ø 5 mm).
f When routing the BUS cable, be careful not to damage the
cable when drilling the fixing holes.
In the area around the power cable entry (behind the wall mount-
ing enclosure), a reservoir needs to be made to hold 20 to 30 cm
of data cable.
C
f Break out one of the knock-outs in the wall mounted
enclosure.
f Route the bus cable through the aperture from the back.
Installing the wall mounted enclosure
D
1 Flush box
f Secure the wall mounted enclosure to the flush box or to the
wall using the screws provided.
Electrical connection
f Connect the bus cable to the ventilation unit. See the installa-
tion instructions for the ventilation unit.
E
1 Appliance
2 Wall mounted enclosure
3 6-pole socket plug
f Connect the bus cable to the female connector.
6-pole socket plug
1
2
3
4
5
6
f Connect the female connector to the back of the appliance.
Completing the installation
f Carefully push the unit into the wall mounted enclosure until
it engages.
10 | FEB
10. Commissioning

10.1 Appliance handover

f Explain the appliance function to users and familiarise them
with how it works.
Note
Hand over these operating and installation instructions to
users for safe-keeping. All information in these instruc-
tions must be closely observed. The instructions provide
information on safety, operation, installation and main-
tenance of the appliance.
11. Specification
11.1 Dimensions
F
11.2 Data table
Height
Width
Depth
Guarantee
The guarantee conditions of our German companies do not
apply to appliances acquired outside of Germany. In countries
where our subsidiaries sell our products a guarantee can only
be issued by those subsidiaries. Such guarantee is only grant-
Not assigned
ed if the subsidiary has issued its own terms of guarantee. No
Not assigned
other guarantee will be granted.
GND
We shall not provide any guarantee for appliances acquired in
+5 V DC
countries where we have no subsidiary to sell our products.
SDA
SCL This will not affect warranties issued by any importers.

Environment and recycling

We would ask you to help protect the environment. After use,
dispose of the various materials in accordance with national
regulations.
FEB
205018
mm
mm 145
mm
www.stiebel-eltron.com
96
31