Genmitsu PROVerXL 6050 Plus Benutzerhandbuch Seite 39

Test Project
2. Run G code for processing
Step 1: Click【open】, select the G
code to run.
Step 2: Click on the manual operation
panel, move the spindle to the
starting. Point of the engraving, so
that the tool and the workpiece just
touch.
Step 3: Click【ZeroXY】【Zero Z】
Clear the XYZ axis coordinate.
Step 4: Click【Send】running G
code.
3. About firmware parameters
The parameters of the control board
have been configured according to
PROVerXL 6050 Plus.
37