Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
28070 Dulcimer stand
USER INSTRUCTIONS / FUNCTION
3. ATTACHING & FIXING THE INSTRUMENT
NOTES
- For a fast and safe installation, we
-
recommend working with two people.
- However, it is also possible to work alone,
-
but with increased caution.
- The more central the center of gravity of the
-
load (= dulcimer), the more securely the stand
-
will rest. The center of gravity changes with the
-
set inclination (readjust if necessary).
3.1 Measure the instrument (depth )
3.2 Loosen the wing screws d.3 and pull both
3.2
adjustment brackets d a few millimeters
3.2
further apart than the dimensions of the dulcimer.
3.3 Fix these positions by tightening the wing screws.
3.4 Place the instrument between the adjustment
3.4
brackets...
3.5 ...with the center of gravity of the dulcimer
3.5
as central as possible above the standpipe.
3.6 Loosen the adjustment brackets and move
3.6
them...
3.7 ...until the dulcimer sits securely;
3.7
now tighten the wing screws again.
3.8 NOTE!
3.8
A change of the inclination angle (section 5)
3.8
is always accompanied by a shift of the center
3.8
of gravity. Please check whether this has a
3.8
negative effect on stability.
3.9 Depending on the size and duration of the
3.9
deviation, we recommend a correction, i.e. the
3.9
adjustment brackets should be moved, (section 6)
3.9
so that the center of gravity of the dulcimer is as
3.9
centered as possible above the standpipe.
4./5./6. SETTINGS
NOTE!
Before making any changes to the stand, we
recommend that the load (dulcimer) either be
removed or secured by a second person.
4. STAND HEIGHT
4.1 Slightly loosen snap-in clamp a.4
4.2 Pull the handle of the snap-in clamp to the rear
4.3 With the handle pulled, extend or retract the
4.3
extension tube
4.4 a Loosen handle and engage bolt;
4.4
b Tighten snap-in clamp again
5. INCLINATION ANGLE OF THE
5.
DULCIMER SUPPORT
5.1 The inclination angle of the support
5.1
can be continuously adjusted between 0°
5.1
(horizontal) and 45°.
5.1
ADVANTAGES:
5.1
- there is a lot of space for
5.1 -
individual adjustments
5.1
- the limit protects against
5.1 -
unintentional tilting.
5.2 To do this, loosen the clamp lever g.1
5.2
slightly, tilt the support to the desired
5.2
position and secure it by firmly tightening
5.2
the clamp lever.
6. ADJUSTMENT BRACKETS
6.1 Loosen wing screws d.3 slightly...
6.2 ...and push both adjustment brackets d
6.2
into position
6.3 Tighten wing screws again.
Werbung
Inhaltsverzeichnis
