Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
28070 Dulcimer stand
2. ASSEMBLY & HANDLING
CROSS SUPPORT c
2.7 Take the four bushings f.3 and g.3 from
2.7
the accessory bags and insert them into
2.7
the upper side holes of the extension tube b.
2.8 The U-sheet of the cross support c
2.8
is pushed over these bushings until
2.8
the holes are aligned.
2.9 Fix upper clamp:
2.9.1 Push washer f.2 over the square
2.9.1
of the screw f.1 and then insert it
2.9.1
through the upper bushings f.3...
2.9.2 ...and lock it by means of the
2.9.2
washer f.4 and lock nut f.5.
2.9.2
Use wrench SW13 f.7 for this purpose.
2.9.2
Finally, press on the protective cap f.6.
2.10 Fix the lower clamp:
2.10.1 Slide washer g.4 over the square
2.10.1
of the screw g.5 and now push it
2.10.1
through the bushings g.3 from the
2.10.1
other side than above...
2.10.2 ...and lock it by means of the
2.10.2
washer g.2 and clamp lever g.1.
ADJUSTMENT BRACKETS d
2.11 Preparation
2.11.1 First remove wing
2.11.1
screw d.3 and washer.
2.11.2 Press cap e.3 into
2.11.2
the open tube end below
2.11.2
the retaining bracket.
2.12 Assembly
2.12.1 Push tube socket into
2.12.1
an opening of the cross
2.12.1
support c and...
2.12.2 ...secure position by
2.12.2
screwing in wing screw
2.12.2
with washer from 2.11.1
2.12.2
again.
2.13 Proceed with the other
2.13
adjustment bracket in the
2.13
same way as described in
2.13
2.11 and 2.12.
FELT STRIPS e
2.14 Felt strips e.1, e.2 are placed on the brackets
2.14
to match the dimensions...
2.15 ...and shape of the dulcimer - mostly at their
2.15
outer ends.
2.15.1 The thin felts (peel off foil) stick to the wall
2.15.1
of the brackets (flush at the top).
2.15.2 The thick felts (peel off foil) are attached to
2.15.2
the bottom of the brackets.
CROSS SUPPORT c
ADJUSTMENT BRACKETS d
FELT STRIPS e
Werbung
Inhaltsverzeichnis
