Safety Precautions - OHAUS Defender 3000-Serie Bedienungsanleitung

Defender 3000 Series U-Pallet Scale
INTRODUCTION
This manual contains installation, operation and maintenance instructions for the i-DFP1500B1 and i-DFP1500C1
Series U-Pallet Scale.

SAFETY PRECAUTIONS

Definition of Signal Warnings and Symbols
Safety notes are marked with signal words and warning symbols. These show safety issues and warnings. Ignoring
the safety notes may lead to personal injury, damage to the instrument, malfunctions and false results.
WARNING For a hazardous situation with medium risk, possibly resulting in severe injuries or
death if not avoided.
CAUTION For a hazardous situation with low risk, resulting in damage to the device or the
property or in loss of data, or minor or medium injuries if not avoided.
ATTENTION For important information about the product. May lead to equipment damage if not
avoided.
NOTE For useful information about the product.
Warning Symbols
General hazard
Safety Precautions
CAUTION: Read all safety warnings before installing, making connections, or servicing this equipment.
Failure to comply with these warnings could result in personal injury and/or property damage. Retain all
instructions for future reference.

Operate the equipment only under ambient conditions specified in these instructions.

Do not operate the equipment in hazardous or unstable environments.

i-DFP1500B1 Series models may be used in dry environments only.

i-DFP1500C1 Series models may be used in wet or dry environments.

Do not load the equipment above its rated capacity.

Do not drop loads on the platform.

Do not place the equipment upside down on the platform.

The foundation at the installation site must be capable of safely supporting the weight of the scale
plus the weight of the maximum load.

Use only approved accessories and peripherals.

Service should only be performed by authorized personnel.
WARNING: Never work in an environment subject to explosion hazards! The housing of the instrument is
not gas tight. (Explosion hazard due to spark formation, corrosion caused by the ingress of gases).
Figure 1. i-DFP1500B1 and i-DFP1500C1 U-Pallet Scales.
Explosion hazard
EN-1