Operation; Operating Elements - Trotec TTK 400 Bedienungsanleitung

Operation

• After being switched on, the device operates fully automatical-
ly.
• Avoid open doors and windows.
Positioning
When positioning the device, observe the minimum distance from
walls of other objects as described in chapter "Technical data".
A
C
D
• Set the device in a level and stable position.
• When positioning the device, keep a sufficient distance away
from sources of heat.
• If possible, set the device in the middle of a room. If using mul-
tiple devices, ensure that the spaces between devices is equal.
• When positioning the device in wet areas, secure the device lo-
cally with an RCD (Residual Current protective Device) which
complies with the appropriate regulations.
• Ensure that extension cords are completely unrolled.
• Ensure that power supply's voltage and current comply with
the specifications on the device's nameplate.
• When using a generator, ensure that the generator supplies at
least 4 kW of power (device starting current can exceed the
nominal current by four or five times. Also note this fact when
using several devices at one generator).
B - 8
B
C
Operating Manual – Construction dryer TTK 400
Notes regarding the dehumidifying capacity
The dehumidifying capacity depends on:
• the spatial composition of the room
• the room temperature
• the relative humidity
The higher the room temperature and relative humidity, the higher
the dehumidifying capacity.
For using in living rooms, a relative humidity of approx. 50-60 %
is sufficient. In store rooms and archives, the humidity should not
exceed approx. 50 %.

Operating elements

9
No. Operating element
3 Operating hours counter
10 Mains switch:
"ON": Device is switched on.
"OFF": Device is switched off.
3
EN