Klarfit Antero Bedienungsanleitung Seite 13

Tensioning the slackline
The slackline should be laid smoothly on the ground between the two fixed
points(see figure 5).
Then thread the slackline through the slotted shaft of the ratchet and pull it as
tight as possible(see figure 6). Only then should the slackline be tensioned with
the ratchet movement(see figure 7).
You can tension the line as far as you can with your body strength using the
ratchet. Under no circumstances should a force amplifier, such as a lever
extension, be used. When you have reached the maximum tension, fold the
ratchet to close it.
As the slackline stretches slightly, it can be re-tensioned several times. A
greater stretch is possible during first use. You can walk more easily on the line
the tighter it is. With lower tension, balancing is more difficult because greater
oscillations occur.
Note: The carabiners must not be attached tightly to the tree(see figure 15
and 16).
Attention: The carabiners must
NOT rest against the tree!
EN
13