Inhaltsverzeichnis
Werbung
-EN
• The exercise cycle has a magnetic brake system. The braking
system is adjustable
• The training device functions RPM-independently /
in case of the chossen Modus.
• Please ensure that liquids or perspiration never enter the
machine or the electronics.
lnstructions for Assembly
LßRISK! Ensure that your working area is free of possible sources
of danger, for example don't leave any tools lying around.
Always dispose packaging material in such a way that it may
not cause any danger. There is always a risk of suffocation if
children play with plastic bags!
• Ensure that you have received all the parts required (see check
list) and that they are undamaged. Should you have any cause
for complaint, please contact your KETTLER dealer.
• Before assembling the equipment, study the drawings carefully
and carry out the operations in the order shown by the diagrams.
The correct sequence is given in capital letters.
• The equipment must be assembled with due care by an adult
person. lf in doubt call upon the help of a second person, if pos
sible technically talented.
• Please note that there is always a danger of injury when working
with tools or doing manual work. Therefore please be careful
when assembling this machine.
List of spare parts page 16-17
When ordering spare parts, always state the full article number,
spare-partnumber, the quantity required and the S/N of the product
(see handling).
Example order:
Art.no. EM1010-410 / spare-part no. 68009222
/ 1 pieces / S/N ................... .
• Before use, always check all screws and plug-in connections as
weil as respective safety devices fit correctly.
• Always wear suitable shoes when using.
dependently,
• Nobody may be in the moving range of a training person during
training
• The Horne Trainer is intended only for indoor use.
• The fastening material required for each assembly step is
shown in the diagram inset. Use the fastening material
exactly as instructed.
• Bolt all the parts together loosely at First, and check that they
have been assembled correctly. Tighten the locknuts by hand
until resis-tance is feit,
completely against resistance (locking device}.
all screw con-nections have been tightened firmly.
once locknuts have been unscrewed they no longer function
correctly (the locking device is destroyed), and must be
replaced.
• For technical reasons, we reserve the right to carry out
preliminary assembly work (e.g. addition of tubing plugs).
• This manual can be downloaded from www.Kettlersport.com.
Waste Disposal
KETTLER products are recyclable. At the end of its useful life please
dispose of this article correctly and safely (local refuse sites).
lt
then use spanner
finally fighten nuts
to
Then check that
Attention:
5
Werbung
Inhaltsverzeichnis
