Battery Operation; Rs-232 Output; Format Entry Order - Giropes Baxtran BCD-Serie Bedienungsanleitung

8. BATTERY OPERATION

•
If you want the scales can operate with the battery. the life of the battery it of approximately 70 hours if only is used the unit basic. if is used a second
platform the life of the battery is reduce.
•
Then the battery need recharge the arrow by over of symbol of battery low under of the display "weight" is light. the battery must be loaded immediately
when appears this symbol. The balance can continue in operation during 10 hours after of the which will automatically turn off to protect the battery.
•
To load the battery just connect the feeder. the balance no need be on.
•
The battery must be charged during 12 hours to recover its capacity maximum.
•
Just under of the display "count" there's a led for indicator the state of the battery when is is recharging. when the balance is plugged the battery internal is
charge. if the led it green the battery is completely loaded. if it red the battery is almost discharged y the yellow indicates that the battery is almost recharged.
NOTA: : It is recommended to recharge the battery before using the scale when the unit has been unpacked.

9. RS-232 OUTPUT

SPECIFICATION
RS-232de Output weight, introduction of erroneous information ASCII Code Baud (600-9600 selectable)
8 bits of information (8 bits of information without parity, 7 bits of information with parity, even or odd selectable.
DB9 CONNECTOR:
Pin 2 RX
Pin 3 TX
Pin 5 GND
Production Example:
LOCAL SCALE ID:
123ABC
NAME: Text
12,456 kg NETO
1.1234 g U.W.
11 PCS
TOTAL
--------------------
49.824 kg TW
44 TPC
4 No.

9.1 FORMAT ENTRY ORDER

The balance can be controlled with the following commands. commands input:
•
The balance has a number of orders for start a action o ok for enter information in the memory. the orders are specified more down.
•
All the orders end with <cr> (button intro of keyboard of pc) with <lf>.
•
If Is receives an order illegal o an order no can be performed, then sends the order of lap adding he front of she. By example if the order it NN<CR y
LF> then sends of lap he NN<CR><LF>.
32
RASTER IN CONTINUOUS FORMAT
ST,GS,- 0.8152kg<CR><LF>
U.W. 0g <CR><LF>
PCS 0pcs<CR><LF>
<CR><LF>
<CR><LF>
ST,GS,- 0.8152kg<CR><LF>
U.W. 0g <CR><LF>
PCS 0pcs<CR><LF>
<CR><LF>
<CR><LF>
OPERATION MANUAL BCD EN EN