Storage And Transport - JSP FAR0801 Anleitung Zu Gebrauch, Pflege Und Überprüfung

COMPATIBILITY
The fall arrestor shall only be used within a fall arrest system according to EN 363 in combination with a full body harness
conforming to EN 361 and connectors conforming to EN 362.
The instructions for use for the individual components are to be observed.
Also ensure that the harness has an attachment point located appropriately in relation to the fall arrester. Use the fall arrester
only with the Anchorage Line supplied by the manufacturer. Do not use rope from any other source.
LIFETIME
The maximum life span of the product is 10 years from the date of manufacture. The life span greatly depends upon the
conditions of usage of the product. Products must be inspected at least once a year by a trained and competent person.
If in any doubts, please contact JSP Safety.

STORAGE AND TRANSPORT

The Personal Protective Equipment must be transported in a package that protects against moisture, mechanical, chemical
and thermal attack. Store in a cool dry place. Avoid humid & acidic environment for storage.
MAINTENANCE
If the product becomes damaged, it will NOT provide the optimum level of protection, and therefore it should be immediately
replaced or repaired. Never use the damaged product. Repairing is permitted, provided that it is either done by the
manufacturer or a competent repair centre or individual approved by the JSP. Proper maintenance of the equipment is
essential for its successful performance.
Regular cleaning is essential:
• In case of minor soiling, wipe with cotton cloth or soft brush. Do not use abrasive material. For intensive
cleaning, it can be washed with water using neutral detergents (pH7). Do not use acid or basic detergents.
Strictly follow the cleaning procedure as mentioned.
• If the fall arrester becomes wet, it should be allowed to dry naturally & kept away from direct heat.
7