Braun Truescan Plus BPW4300 Handbuch Seite 13

Connection to the PC and Data Transfer
To connect your PC to your Braun TrueScan Plus, please use the USB cable enclosed
in the pack and make sure that the device is turned off . When you see the "O" wheel
and "PC" on the LCD display it means that the device is ready to transfer data to your
PC. You can transfer the data by clicking the "Transfer" menu/button on the top of the
window in the BP Smart Manager software application. On the "Transfer" screen you
click the "Transfer" button. After transferring the data please disconnect your device
from the PC and turn the device off . To transfer data a second time, reconnect the USB
cable and repeat the above steps.
Warning:
You can't perform any measurement, when your device is connected
with the USB cable to the PC.
Choose Install Location:
Choose the folder in which to install Braun BP Smart
Manager™. Setup will install Braun BP Smart Manager™ in
the following folder. To install in a diff erent folder, click
"Browse" (Browse) and select another folder. Click "Next"
(Next) to continue.
Choose a Start Menu folder for the Braun BP Smart
Manager shortcuts. Select the Start Menu folder in which
you would like to create the program's shortcuts. You can
also enter a name to create a new folder. Click "Install"
(Install) to continue.
Braun BP Smart Manager has been installed on your
computer. Click "Finish" (Finish) to close this wizard.
13