Operation Method - Sublue WhiteShark Tini Bedienungsanleitung

Operation Instructions
1
Operations
Item

Operation Method

Press the propulsion system
Turn on
switch/networking dial for 3s. When
propulsion
the propulsion system indicator is on,
system 1
the system has turned on.
Long-press the controller switch/gear
Turn on
button for 3s. When the controller
controller
indicator is on, the controller is on.
Propulsion When the device is off, press the
system propulsion system switch/networking
networking dial for 6s to enter networking mode.
2
When the device is on, long-press the
Controller
controller networking button for 3s to
networking
2
enter networking mode.
After the device is on and networked,
Adjust the
press the controller switch/gear
speed setting button once to adjust the speed by
4
one level.
13
Diagrams Remarks
The default speed setting upon
startup is "Low speed".
The default speed setting upon
initial startup is "Low speed". The
"Start" button cannot be pressed
during startup.
After turning the knob for 3 seconds
to turn the device on, do not let go
and continue turning the knob for 6
seconds. After successful
networking, the device will
automatically exit this mode.
After successfully networking the
propulsion system and controller,
press the "Start" button on the
controller to exit networking mode .
3
There are two speed settings. When
the device is restarted, it returns to
the "Low speed".
Item Operation Method
① When the device is on and you press
the propulsion system switch/network-
ing button for 3s;
Turn off ② When the device automatically shuts
propulsion
down because no operation was
system
performed for 40min;
③ When the device is running and the
battery is critically low.
① When the device is on and you
long-press the controller switch/gear
button for 3s;
② When the device automatically shuts
Turn off
down because no operation was
controller
performed for 10min;
③ When the device is running and the
battery is critically low.
When the propulsion system and
controller are on and networked,
Motor startup continue to press the controller "Start"
mode 1
button to keep the propulsion system
thrusters activated.
When the propulsion system and
controller are on and networked, install
the magnetic safety rope in the
designated location and press the
Motor startup
"Start" button on the controller for 3s to
mode 2
keep the propulsion system thrusters
activated.
Diagrams Remarks
All the propulsion system
indicator lights turn off.
All the controller indicator lights
turn off.
Press the button to move and
release it to stop.
The motor will stop running
when you press the "Start"
button again or the safety rope
is disconnected.
14
EN