Operating - Sublue WhiteShark Tini Bedienungsanleitung

*1. When the propulsion system is on, do not perform any operations on the controller.
*2. Perform networking before installing the propulsion system on the inflatable kickboard.
*3. Because the controller can control multiple propulsion systems and cannot judge the
number of propulsion systems to connect with during networking, the operator must use
the indicator lights to determine when networking is complete and then press the "Start"
button on the controller to take the controller out of networking mode.
*4. Because the controller and propulsion system can be turned on and operated
separately, they may not be set to the same speed setting after startup. In such cases,
the speed setting of the controller will prevail. In addition, all controller operations (except
for starting networking mode) will instruct the propulsion system to change its speed
setting to be consistent with the controller.
2
Safety Rope Usage Instructions
1. Attach the safety rope to your wrist and use the buckle to adjust it to a proper tightness.
2. Attach the magnetic clip of the safety rope to the magnetic interface on the controller.
You can use motor startup mode 2 when using the safety rope. This turns the
propulsion system off if the user falls off to prevent hazards.
15
3
Indicator Light Description
Indicates the LED light flashes regularly
Indicates the LED light shines steadily
Indicates the LED light is off
Ａ Ｂ
Both LED lights shine steadily
Ａ Ｂ
Both LED lights are off
Ａ Ｂ
LED B flashes
Ａ Ｂ
Both LED lights shine steadily
Ａ Ｂ
Indicates the device battery level
Ａ
Ｂ
LED A flashes
Ａ
Ｂ
LED A shines steadily
1. When the control starts to display the low battery warning, it can operate for another
30 minutes, so ensure you have enough time remaining to return to shore.
2. Turn off the controller before charging.
3. Because the propulsion system information is not visible from on top of the inflatable
kickboard, you need to go to shore or another safe place to check it.
Led A
Led B
On
Off
Networking Flashing green
High speed - Red

Operating

LED A：
Low speed - Green
Low battery warning LED A： Battery < 30%
Charging LED A： Red
Charging complete LED A： Green
EN
16