Care And Maintenance - Sublue WhiteShark Tini Bedienungsanleitung

4
Inflatable Kickboard and Controller Storage and Maintenance
1 The products should be stored at 25±5℃, with an optimal humidity of 65±20％RH. The controller
battery level must be maintained at around 30% to 60%, and the inflatable kickboard and
controller must be stored in a cool, dark, and well-ventilated environment.
2
Do not place the product in direct sunlight or areas with high temperatures (such as near
microwave ovens and ovens). Battery overheating may cause fire or explosion, and the
material of the inflatable kickboard will rapidly age and become damaged in a
high-temperature environment.
3
Do not place the product near a fire source as it may combust or explode.
4
Do not charge the controller near fire or heat sources.
5
Do not drop, squeeze or puncture any part of the product as this may cause air leakage,
battery leakage, fire, or explosion.
6
Do not disassemble or modify the battery. Unauthorized modification may cause battery
leakage, fire, or explosion.
7 Store the product out of the reach of children.
8 Do not charge the controller at temperatures below 0℃.
9 When using the controller at temperatures below 0℃, the battery power will be drastically
reduced, resulting in a far shorter operating time.
10
For safety reasons, the controller must be kept at a low battery level during transportation.
Discharge the battery to 30% before transportation.
11
Do not use damaged products.
12
If electrolyte leaks from the battery and enters the eyes, do not rub them. Rinse the eyes with
water and seek immediate medical attention. If not treated quickly, this can cause injury to the
eyes.
13
During long-term storage, check the controller battery at least once every 6 months and keep it
charged to at least 60%.
17

Care and Maintenance

Cleaning After Use
After each use, clean the product with fresh water within 30 minutes to wash off any
salt water and foreign matter. Also, observe the following precautions:
* Use clean, fresh water.
* When cleaning, you can wipe the product with a soft cloth, but not with a hard material.
* Do not use any chemical cleaning products, such as laundry detergent or cleanser, to
clean the product.
* The magnetic charging port can easily absorb iron filings in the water. Please wipe it
with a soft cloth when cleaning.
For cleaning instructions for the Tini propulsion system, see the WhiteShark
Tini User Manual.
General Troubleshooting Instructions
Fault Solution
1. Check that the propulsion system and controller batteries are
charged
2. Check that the propulsion system and controller can start up
Motor cannot normally and the indicator lights are normal
turn on 3. Check that the propulsion system and controller can be
networked normally and the speed can be adjusted
4. Check that the propellers can move
5. Contact Sublue or a Sublue-authorized aftersales service site
The controller LED 1. Check that the controller can start up normally
indicator lights are 2. Check that the controller can be charged normally
abnormal 3. Contact Sublue or a Sublue-authorized aftersales service site
EN
18