Names And Contents Of Harmful Substances In Products - Sublue WhiteShark Tini Bedienungsanleitung
Vorschau ausblenden
Andere Handbücher für WhiteShark Tini:
- Bedienungsanleitung (56 Seiten) ,
- Betriebsanleitung (12 Seiten) ,
- Betriebsanleitung (220 Seiten)
Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Names and Contents of Harmful Substances in Products
Pb
Hg
Cd
Cr6（VI）
PBB
Circuit
O
O
O
O
O
board
assembly
Plastic
O
O
O
O
O
(glue)
parts
O
O
O
O
O
Metal
parts
O
O
O
O
O
Power
cord
O
O
O
O
O
Adapter
O
O
O
O
O
Charging
seat
O
O
O
O
O
Battery
O
O
O
O
O
Other ac-
cessories
This form is prepared according to SJ/T 11364.
O: Indicates that the content of the harmful substance in all homogeneous materials of
the component is below the limit as specified in GB/T 26572;
X: Indicates that the content of the harmful substance in at least one uniform material
of the component exceeds the limit specified in GB/T26572
Note: This product uses environmentally protection design concepts to effectively
control harmful substances. The harmful substances indicated by "X" cannot be
replaced, mainly due to technological development limitation.
21
Harmful substance
PBDE
DIBP
DEHP
BBP
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
Environmental Protection Service Time:
This mark refers to the time limit (ten years). Within this period, the harmful
substances contained in the electrical and electronic products will not leak or
DBP
abrupt changes under normal use. It will not cause serious pollution, bodily
injury, or damage to property.
O
Tips for exhaust gas recovery:
In order to better protect the earth, when users no longer need the product or the
O
products service life comes to the end, please comply with the national laws and
regulations on disposal of waste electrical and electronic products and hand it over to
the local manufacturers with approved qualifications for recycling.
O
O
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
O
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
O
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
O
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
O
one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
EN
22
Werbung
Inhaltsverzeichnis
