CeraGem CGM MB-1101 Bedienungsanleitung Seite 46

2. Attached documents
Manufacturer's declaration - electromagnetic immunity
The CGM MB-1101 is intended for use in the electromagnetic environment
specified below. The customer or the user of CGM MB-1101 should assure
that it is used is such an environment.
Immunity test
Electrostatic
discharge
(ESD)
IEC 61000-4-2
Electrical fast
Transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Power frequency
(50 or 60Hz)
Magnetic field
IEC 61000-4-8
Voltage dips, short
Interruptions and
Voltage variations
on power supply
input lines
IEC 61000-4-11
Note : т is the a.c. mains voltage prior to application of the test level.
U
44
IEC 60601
Compliance level
Test level
6kV Contact 6kV Contact
8kV Air 8kV Air
2kV for power 2kV for power
supply lines 1kV
supply lines 1kV
for input/output for input/output
lines lines
1kV differential 1kV differential
mode mode
2kV common 2kV common
mode mode
30 A/m 30 A/m
0% т (100% 0%
U
dip in т) dip in
U
for 0.5 cycle for 0.5 cycle
0% т (100% dip 0%
U
in т) for 5 cycle in
U
70% т (30% dip 70%
U
in т)for 25 cycle in
U
0% U т (100% 0%
dip in т) dip in
U
for 5 s for 5 s
Electromagnetic
environment - guidance
Floors should be wood,
concrete or ceramic tile.
If floors are covered with
synthetic material, the
relative humidity should be
at least 30%.
The main power's quality
should be that of a typical
commercial or hospital
environment.
The main power's quality
should be that of a typical
commercial or hospital
environment.
Power frequency magnetic
fields should be at levels
characteristic of a typical
location in a typical
commercial or hospital
environment.
т (100% The main power's quality
U
т) should be that of a typical
U
commercial or hospital
environment. If the user of
т (100% dip the CGM MB-1101 requires
U
т) for 5 cycle continued operation during
U
power mains interruptions,
т (30% dip it is recommended that the
U
CGM MB-1101 be powered
т)for 25 cycle
U
from an uninterruptible
U т (100% power supply or a battery.
т)
U