Babboe Carve Montageanleitung Seite 18

Babboe City & Babboe Mini
Preliminary remarks
There is no need to drill extra holes in the box in order to install the Maxi-Cosi carrier in the Babboe City and
Babboe Mini, since you will be using the existing holes in the box.
The Maxi-Cosi carrier consists of two parts:
• Part 1: the base at the bottom of the box
• Part 2: the carrier for the Maxi-Cosi
Tools required:
• Open-end/ring spanner size 10
• Phillips screwdriver
• From the supplied sachet you will need:
- The two long bolts
Montage
Step 1:
Preparations
Hold the nuts underneath the bottom panel in place using a ring spanner and unscrew the bolt with a
Philips screwdriver.
Babboe Mini: In order for the Maxi-Cosi to be used in the Babboe Mini, the bench needs to be removed
from the box.
Step 2:
Installing the base on the bottom
Use the two long bolts from the sachet to secure the base to the bottom
panel. Place the base with the long strip on the two spots where you
just removed the bolts from. Then securely tighten the two nuts and
bolts. Make sure the latch mechanism is on the top side.
18