Babboe Carve Montageanleitung Seite 16

Babboe Curve
Preliminary remarks
Before starting installation, we advise you to check the packaging to ensure all parts are included.
The required parts are:
• Sachet including:
- Two long bolts
- Two lock nuts
- Two metal rings (between lock nut and wood)
- Two large metal washers
- Two caps
The Maxi-Cosi carrier consists of two parts:
• Part 1: the base at the bottom of the box
• Part 2: the carrier for the Maxi-Cosi
Tools required:
• Phillips screwdriver
• Open-end/ring spanner (size 10)
Installation
Step 1:
Preparations
In order to use the Maxi Cosi carrier, the belts at the front of the box must first be loosened. To do so, push the
belt clips through the holes in the front panel. Then remove the bench at the front, including the belts. To do so,
pull the bench towards the handlebar and out of the guides. Ensure to give the latch at the bottom some room.
*The front of the cargo bike is shown in this manual as if it would be seen by you if you were sitting on the saddle.
Step 2:
Removing the caps from the bottom panel
1. Take a knife and put the blade behind the caps on the bottom panel.
2. Pry the caps out.
16