Placing The Maxi-Cosi In The Carrier - Babboe Carve Montageanleitung

Step 3:
Installing the base on the bottom
Place the bolts in the holes of the base. Put the metal
washers over the bolts. Then place the base on the
bottom panel in the holes (as shown in the picture).
Tighten the nuts using the open-end spanner and
screw driver.
Step 4:
Installing the carrier onto the base
Place the carrier onto the base by 'hooking' it behind
the front metal strip. Then tilt the carrier downward
between the two rear strips. Now turn the latching
mechanism so the carrier is firmly secured to the base.
The carrier is now ready to use.
Stap 5:
Secure locking of the Maxi-Cosi carrier
To ensure that the Maxi-Cosi carrier stays securely in place
and to prevent theft, use the supplied lock. Pass the clasp
through the hole in the locking mechanism and lock.
Step 6:

Placing the Maxi-Cosi in the carrier

In order to correctly place the Maxi-Cosi in the carrier,
the carrying handle should be in the upright position.
Secure the two rubber bands on both sides of the
carrier, with the closed side of the hook facing inwards.
Secure the hooks on the front of the carrier to the lower
"rods" (see A in the picture on the right).
You are now ready to take your baby in the Maxi-Cosi
carrier in your Babboe cargo bike. Wishing you lots of
cargo bike fun!
Instruction manual Maxi-Cosi carrier
Carrying handle in
the upright position!
Secure the rubber bands on both sides. Closed side of the
hook facing inwards. Front hook attached to lower rod!
17