Preliminary Remarks; Tools Required - Babboe Carve Montageanleitung

Babboe Carve & Babboe Flow

Preliminary remarks

There is no need to drill extra holes in the box in order to install the Maxi-Cosi carrier in the Babboe Carve &
Babboe Flow, you will be using the existing holes in the box.
The Maxi-Cosi carrier consists of two parts:
• Part 1: the base at the bottom of the box
• Part 2: the Maxi-Cosi carrier

Tools required:

• Open-end/ring spanner 10
• Allen key size 4
• From the supplied sachet you will need:
- the two large metal washers
Installation
Step 1:
Preparations
Unscrew the two bolts in the box with the Allen key and
open-end/ring spanner. Keep the nuts, bolts and metal
washers handy, you will be using them later on.
Step 2:
Installing the base on the bottom
Place the bolts in the inner holes of the base. Put the metal
washers over the bolts. Then place the base on the bottom
in the holes (as shown in this picture).
Put the washers and nuts back on the underside of the
box and tighten the bolts until the base is firmly fixed
in place.
14