User manual / Bedienungsanleitung
1. Contents
Please check all contents of your package:
smart power 12V (
1.
2. 19V wall mount power supply
3. User manual
4. Warranty card / Quality card
2. Getting started
Clearaudio smart power 12V
The
packaging to ensure safe transportation if needed.
Unpack the unit and place it at its desired location.
smart power 12V
Connect the
supply. Then connect your turntable to the
of the usual power supply.
Note: Never connect the 19V pow er supply direct to your concept series turntable.
Serious damage can occur.
smart pow er 12V
Before using
to the optimum operating condition ( see page 5, point 3.3, "Charging mode") .
smart power 12V
To switch the
smart power 12V is now in the output/off mode, the LED ring of the button on the front will
The
brighten up and vanish after a few seconds.
Press the button shortly, to activate the unit and to supply the turntable with power.
4
with hard wired power cord, length 160cm)
is delivered in custom-designed packaging. Please keep this
to the mains power supply with the supplied 19V wall mount power
smart power 12V
it is important to fully charge internal battery to bring it
on, use the switch on the rear side of the unit.
using the attached power cord, instead
© clearaudio
electronic GmbH, 2021-03