Maintenance And Service; Maintenance And Cleaning - Bosch PEX 400 A Originalbetriebsanleitung

OBJ_BUCH-434-001.book Page 22 Friday, September 28, 2007 10:52 AM
22 | English
Application Table
The data in the following table are recommend-
ed values.
The most favourable combination for working is
best determined by practical testing.
Roughening
varnish 180/320
Touching up
varnish 120/400
Removing
varnish 40/80
Softwood 40/240
Hardwood 60/320
Veneer 240/320
Aluminium 80/240
Steel 60/240
Derusting steel 40/120
Stainless steel 120/240
Masonry, stone 80/200
1 609 929 M11 | (28.9.07)

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
2/3 soft
4/5 hard
Do not connect the blue or brown wire to the
5 medium
earth terminal of the plug.
5/6 medium
Important: If for any reason the moulded plug is
5/6 medium
removed from the cable of this power tool, it
must be disposed of safely.
2 – 4
soft
4/5 medium
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
5 medium/
should be carried out by an after-sales service
hard
centre for Bosch power tools.
6 soft
In all correspondence and spare parts order,
5 medium
please always include the 10-digit article
5/6 hard number given on the type plate of the machine.
Bosch Power Tools