Fiem SMART Betriebshandbuch Seite 11

POSITIONING, LACING AND PREPARATION
The room where machine is placed, shall be enough aired and dry, at a constant temperature between 18-25 °C.
Il costruttore declina ogni responsabilità nel caso di uso improprio, di collocazione
Place the incubator on a plan surface not tilted and possibly near to an electric intake of easy access. For a
net supply, use only the electric plugs supplied with earth connection.
ADVICE: The builder declines every responsibility in case of any improper use or improper placement, connec-
tion to any authorized apparatus or tampering from not authorized personal.
Insert the thermometer into the plastic clip on top of the support of the eggs wire net, paying attention to do
not break it and regulate it with its bulb at the middle line of the eggs.
• Before using the machine, remember to clean carefully the machine inside and outside, as showed in para-
graph n° 5.
IMPORTANT NOTICE: In order to comply with the latest CE specifications
in terms of human safety from dangerous materials contained on electric
and non electric equipments we have been obliged to conform our mercury
thermometers/hygrometers to the actual rules via the replacement of the
now forbidden mercury with colored liquid. Being this last one physically
more volatile and subject to fragmentations, sometimes invisible because
of his discoloration, the result is that the new thermometers are less reliable. Consequently we ask our esteem
customers & distributors to pay the maximum attention before using our thermometers, examining that there
are no gaps visible in the colored liquid and while storing caring them to be positioned vertically. The adequate
room temperature for storing our thermometers is comprised between 10°C to 30°C.
EGG-TURNING KIT ASSEMBLING: The egg-turning kit allows the eggs to be turned automatically by a hori-
zontal movement of the plastic grid placed on the wire net, this movement is slow and delicate. The egg-turner
motor is placed inside plastic box attached lateral to the inferior part of the machine and it is insulated and
protected by a plastic cover. Connect the plug to an electric intake of easy access and make sure that moving
starts; please note that egg-turner motor does 1 rp clockwise direction of 360° per hour which is transformed
in linear movement go and back each of 30 minutes.
If the incubator is manual for turning eggs, remember to turn the eggs by the rod of the grid one time go and
one time back twice per day (morning and evening).
ATTENTION: Inside egg-turner plastic box there is electric tension 230V, so before to open the box
for any possible checking, make sure that plug is not connected to electric network.
USE AND CALIBRATION
For the switching on the machine connect the electric plug to the electric network and before to load the
eggs await for the incubator has reached the working temperature of 100°F(37,7°C). Positing gradually the
ready eggs for the incubation on the wire net, only when the incubator has reached the working temperature
of 100°F.
Loading the eggs conserved not later then 7- 8 days and not earlier then 3 days from deposition -
before the incubation, the eggs must be conserved in a local with temperature between 14 – 16 °C.
On the upper part, it is placed the thermostat, (which has been set-up by the factory, when it is working, the
green led results light, the continuous or intermittent lighting of the red led points out the activation of the
heating.
We recommend to pay attention to the thermometer with colored liquid, which has to mark 100°F (37,7°C),
always in a precise way.
If it had not to reach the working temperature above marked, the thermostat should be set as follows:
It is important to remind that the local conditions where the machine is placed (temperature, humidity and aeration) do not influence
1
sensibly on the temperature inside the unit while can condition not indifferently the inside humidity values.
1
11