Control Panel And Functions - Klarstein VINSIDER 52 UNO Bedienungsanleitung

EN
36

CONTROL PANEL AND FUNCTIONS

POWER: Press this button to switch the appliance on and off. To switch off
the appliance, hold the button for 5 seconds
LIGHT: With this button you can switch the light in the interior on and off.
HIGH: Increases the temperature by 1 °C / 1 °F) each time the button is
pressed.
DOWN: Decreases the temperature by 1 °C / 1 °F each time the button
is pressed.
You can select whether the temperature is to be displayed in °C or °F.
°C/°F To switch between the two units, press and hold the LIGHT button for 5
seconds....
• It is possible to set the temperature degree by degree. The temperature can be
adjusted with the UP or DOWN buttons to the right of the temperature display. The
adjustable temperature range is 5-22 °C / 40-72 °F.
• In standard operation, the set temperature appears in blue in the temperature
display window. When you increase or decrease the temperature, the display
shows the desired temperature.
• To display the current indoor temperature, press the UP button for 5 seconds. The
current indoor temperature is then temporarily shown on the display for 5 seconds.
After a few moments, the display shows the set temperature again.
• Pressing the HIGH button once increases the temperature by 1 °C / 1 °F.
• Pressing the DOWN button once decreases the temperature by 1 °C / 1 °F.
Note: If the ambient temperature is 25°C and the wine cooler has no bottles loaded,
it takes about 30 minutes to raise the temperature of the wine cooler from 5°C to
12°C. Under the same circumstances, it takes about an hour to lower the temperature
of the wine cooler from 12 °C to 5 °C.