Changing The Settings - AFRISO EURO-INDEX Unimes Betriebsanleitung

3.1.1 Tank without manhole or flange connection piece
1. Move the float to seal 2.
2. Fix seal 3.
3.1.2 Tank with manhole or flange connection piece
1. Measure the height of the manhole or the flange connection piece.
2. Plot the measure of the projection of the manhole or the flange con-
3. Mark the position.
4. Slide the float to the mark.
5. Fix seal 3.
3.2 Adjusting the measuring range

3.2.1 Changing the settings

1. Pull out as much float wire as required by the height of the tank.
Unimes
nection piece to the length of the float line from seal 2 towards seal
1.
The mechanical level indicator UNIMES is factory-adjusted to the
maximum tank height.
Fig. 2: Adjusting the measuring range

Take into account the projection of the manhole or the flange
connection piece when doing so.
4