AVENLI SPA4 Benutzerhandbuch Seite 18

Troubleshooting
Here are some useful tips to help you to diagnose and rectify common sources of
trouble.
Problem Cause
Control panel
screen does Check power source
not operate
Temperature set is too low
SPA pump
Filter Cartridge is dirty
does not heat
properly
Too low water level
Heating element defective
Pump is overheating
Bubble
massage
Auto shut-down feature
system does
(30min) is activated
not work
Malfunction of the pump unit
Filter Cartridge is dirty
Water
filtration does Inlet and outlet blocked
not work Air inside the pump
Malfunction of the pump unit
Adaptor seal improperly
Pump leakage Water leakage from pump
body
Spa pool
Spa pool is torn or punctured
leakage
Insufficient filtering time
Filter Cartridge is dirty
Water is not
clean Pool filled water quality
Improper water treatment
After 150 cumulative hours of filtration operations, an audible alarm
will sound and the LCD display will show the characters CHG,
followed by FIL, to remind you to change or clean the filter. You can
CHG FIL
hold the filtering button 5 seconds to turn off the buzzing. The
filtering system will turn off, you can press the button to active the
filtering system again.
Solution
Power failure
Reset the RCD plug / Check if the
wiring system is adapted to the
power of the pump unit.
Call for service if it does not reset
Set to a higher temperature
Clean or Replace the cartridge (see
chapter - Cleaning)
Fill water to minimum water level
Call for service
Cut off the power and wait until the
pump has cooled.
Press the bubble button to
reactivate
Call for service if it does not reset
Clean or Replace the cartridge (see
chapter - Cleaning)
Clean the inlet and outlet
Fill water to minimum water level
Call for service if it does not reset
Replace the seal in the right position
Check the pump body, call for
service
Use provided repair kit (see chapter
– Repair kit)
Increase the filtering time
Clean or Replace the cartridge (see
chapter - Cleaning)
Change the pool water completely
Refer to the chemical
manufacturer's instructions