Assembly - PLAYKIN BENTLEY Betriebsanleitung

TECHNICAL DATA
Battery
Charger
Charging time
Adequate age
Maximum load weight

ASSEMBLY

ATTENTION
×
The assembly must be carried out by an adult. Keep children away, the product
contains small parts that can cause asphyxiation, pay special attention to protective
materials and packaging bags.
×
Consult the assembly of the wheels according to the model of your vehicle.
×
Make sure the power switch is "OFF" before mounting the equipment.
−
Before first use, charge the battery for at least 4 to 6 hours.
−
Required mounting tools: Screwdriver (not included) and key.
−
An additional wrench is provided to hold the lock nut on the other side of the rear axle while
tightening the lock nut on the other side.
SECURE REAR WHEELS (MODEL 1)
Drive wheell
10
×
Turn vehicle body upside down.
×
Remove all parts from the rear axle.
1. Slide the gearbox over the rear axle (left side). Keep the engine and gearbox connector through
the largest hole in the rear vehicle and out of the battery location.
2. Slide the drive wheel over the rear axle. And keep the drive wheel at the height of the gearbox.
3. Slide the Ø10 washer onto the rear axle.
4. Tighten the end lock nut with a wrench.
BENTLEY
4 3
59
6V 4Ah (x2)
12V 1000mA
8-12h
37-96 months
30kg
Bottom rear view
1
Rear axle
2
EN