PLAYKIN BENTLEY Betriebsanleitung Seite 60

5. Slide the washer Ø10 onto the rear axle (right side).
6. Insert the bushing into the hole in the center of the normal wheel.
7. Slide the Normal wheel over the rear axle.
8. Slide the Ø10 washer onto the rear axle.
9. Tighten a locknut on the end of the rear axle with a wrench.
TIP: An additional wrench has been provided to secure the lock nut on the other side of the rear
axle while tightening the lock nut on the other side.
10. Mount the hubcaps on the wheel.
SECURE REAR WHEELS (MODEL 2)
Drive wheel
5
×
Turn vehicle body upside down.
×
Remove all parts from the rear axle.
1. Remove all parts from the rear axle. Slide the gearbox over the rear axle. "The gearbox with the
"R" label must be fitted to the "R" side of the vehicle body; the gearbox with the "L" label must
be fitted to the "L" side of the vehicle body. Keep the engine and gearbox connector through
the larger hole at the rear of the vehicle and out of the battery location.
2. Slide the drive wheel over the rear axle. And keep the drive wheel at the height of the gearbox.
3. Slide the Ø10 washer onto the rear axle.
4. Tighten a locknut on the end of the rear axle with a wrench.
TIP: An additional wrench has been provided to secure the lock nut on the other side of the rear
axle while tightening the lock nut on the other side.
Repeat the above procedure to mount the other drive wheel.
5. Mount the hubcaps on the wheel.
5
6
4 3
60
Normal Wheel
10
7
8
9
Bottom rear view
1
2
Rear axle