PLAYKIN BENTLEY Betriebsanleitung Seite 68

2.4G REMOTE CONTROL
Forward
button
Brake button
Back button
ATTENTION: The remote control should only be used by adults.
NOTA: The remote control has priority over the pedal. (The pedal will not work while you
are using the remote control).
ASSEMBLY
Lift the battery compartment door on the back of the controller and insert two AAA(LR03) batteries.
NOTA: Batteries not included. Refer to battery information.
1. Connection button (establish connection):
Press the engage button for 2~4 seconds first, then turn on the ignition button on the vehicle
dashboard console, when the low speed indicator changes from flashing to flashing continuously,
it means that the engagement has been made correctly. If the low speed indicator only flashes, it
means that the connection has failed. Replace the batteries and repeat the above steps...
2. Brake button:
Press the button to stop the vehicle, press it again to release the brake.
3. Speed selection button:
The switch operates the vehicle to move at low, normal or high speed.
NOTA
×
The vehicle is designed to operate only at low speed in reverse.
×
Leave the remote control inactive for about 10 seconds for automatic power off.
×
Repeat step 1 when replacing the batteries in the remote control.
Speed selection button
68
Connection button
Push-button
on the left
Push-button
on the right
- High speed indicator
- Normal speed indicator
- Low speed indicator