Samson 024.50 Originalbetriebsanleitung Seite 70

Original Betriebsanleitung
Typ 024.50
On site programming
On site programming is performed by means of a light signal and can only be initiated during the
boot process of the contact-free limit switch.
→ Set the linear actuator to the "closed"
position.
→ Screw on 5- or 4-pin M12 connector with
power supply.
→ The LEDs start flashing purple.
→ You now have about 20 seconds to generate
three light pulses with a flashlight, each of
which is confirmed with a color change from
violet-orange-violet
Photodiode
„
Periscope"
→ The LEDs are now permanently purple and the
programming mode has been activated.
→ If it is a two-stage actuator, move it to the
middle position. If the point has been taught in
successfully, the LEDs will flash green-violet as
confirmation.
→ Move the actuator to the "open" position. If
the point has been taught in successfully, the
LEDs flash green-violet as confirmation.
→ Move the actuator to the "closed" position. If
the point has been taught in successfully, the
LEDs flash orange-violet and afterwards
continuously blue.
© 1994 - 2022 SED Flow Control
Move valve to closed
position
Screw on 5-pin
connector
Display flashes
violet for 20 sec.
Flashlight within aim at
the starting point for 20
sec. until the LEDs light
up orange.
Switch off the flashlight
and repeat the process 3
times
Display changes
from orange to
flashing violet.
Wait until
display lights up
violet
Open valve
Display flashes green -
violet. On top position
display changes from
green - violet flashing to
continuous mode violet.
Close actuator. Display
flashes violet - orange in
closed position.
Afterwards permanently
blue.
Programming finished
28
2-Stage
actuator
Move the valve to the
middle position. LEDs
flash green - violet
In center
position, LED's
light up violet
BA_024.50_v03 Version: a