DeWalt DCB094K Originalanweisungen Seite 52

EnGLIsh
nOTE: Do not plug in devices that exceed the output ratings on the power source's
label. Doing so will shorten the USB charger's useful life.
D WALT batteries will charge, via the USB Type C port from most USB power supplies. Some
e
power supplies may require a different cable not supplied with this kit, and may charge at
a slower rate.
Charging a Device
Insert a USB plug into the USB Type‑A port
power or charge your devices.
nOTE: There will be no LED indication while supplying power to or charging user devices.
LEDs will only illuminate when charging D
nOTE: The USB ports will shut down and the yellow LED will blink if the battery pack
temperture is out of acceptable range.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and
***
other countries.
**** Apple is a trademark of Apple Inc.
Belt Clip ( Fig. C)

WARNING: To reduce the risk of serious personal injury, ensure the screw holding the
belt hook is secure.
IMPORTanT: When attaching or replacing the belt hook
only the screw that is provided. Be sure to securely tighten screw.
11
If the hook is not desired at all, it can be removed from the D
To remove the belt hook, remove the screw
MAINTENANCE
Your USB charger has been designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends upon proper care and
regular cleaning.

WARNING: To reduce the risk of serious personal injury, disconnect battery
pack before making any adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.
The charger and battery pack are not serviceable.
C
Lubrication
Your USB charger requires no additional lubrication.
50
4 or bi‑directional USB Type‑C port
WALT batteries.
e
, to the D
10
e
that holds the belt hook in place.
11
5
WALT USB charger, use
e
WALT USB charger.
to supply