Firmware-Update - dtm mark Montage- Und Betriebsanleitung

4.7. Formatting memory
In order to format the receiver's memory, press and hold two buttons on the receiver for
10 seconds.C1,C2,C3 diodes will start flashing.The buttons should be released only when
the LEDs go out.
Formatting memory:
removes all remotes from the receiver,
•
sets the channel operation mode to monostable with a switching time of 1s.
•
C1
C2
C1
C3
MOM
MONO
C2
BIST
POW
C3
PRESS AND HOLD
1
THE TWO RECEIVER
BUTTONS
Fig. 7 Formatting the memory.
5.Confirming the transmission in theCSS system
In the CSS system, it is possible to transmit the signal back from the receiver, which is a
confirmation of channel control.
The confirmation is sent by the receiver only when requested by the transmitter.
In the STARK remote control, each short press of the remote control function button
causes sending a radio signal along with a request for confirmation from the receiver. A
longer pressing of the transmitter button, over 400ms, causes sending a radio signal
without requesting a confirmation.
When controlling the receiver channel set in the momentary mode, in which the control is
carried out using a long-pressed remote control button, we will not receive confirmation
of channel control.
A longer pressing of the remote control button in the monostable or bistable mode will
result in no confirmation being sent.
6. Firmware update
The receiver is equipped with a micro USB connector for connecting to a computer with a
cable.Connecting the receiver to a computer allows you to update the receiver's firmware
using theCSSUPDATE program.The program is available for download on the producer's
website www.dtm.pl
C1
C2
C1
C3
MOM
MONO
C2
BIST
POW
> 10s
C3
2
C1, C2, C3 WILL BLINK
C1
C2
C1
C3
MOM
MONO
C2
BIST
POW
C3
RELEASE BUTTONS
3
WHEN C1,C2,C3 LEDS
GO OFF
21