Werbung
1. Important information
Please read this manual completely and attentively before using the product for the first time. Keep this manual. It is part
of the product.
All figures and tables are to be found at the end of the manual.
1.1 Safety instructions
Caution:
Possible hazards!
When handling magnets, wearers of pacemakers should exercise the usual caution.
Magnets are no toys. There is the danger of swallowing the magnets. They must therefore be kept out of the reach of
children as long as they are out of their packaging and not mounted! Moreover, magnets may easily break or splinter
under mechanical pressure!
1.2 Using the product for its correct purpose
This product is intended:
- For remote control and switching CarMotion vehicles on and off.
- For operation in dry rooms only.
Using the product for any other purpose is not approved and is considered inappropriate. The manufacturer is not
responsible for any damage resulting from the improper use of this product.
1.3 Checking the package contents
Check the contents of the package for completeness:
- IR remote control including button cell battery (CR2025)
- Manual
2. Vehicle configuration and control with IR remote control
Hint: Before first use, remove the battery fuse!
The remote control facilitates the control of the CarMotion vehicles on the layout as well as simple settings at the vehicle.
For this purpose the remote control is directed towards the front part of the vehicle where its infrared sensors are located.
Distances larger than 50 cm require a very precise alignment of the remote control with the vehicle. Under favourable
conditions a distance of up to 1 m is possible. For optimal alignment, see fig. 1. The device is designed for a local control
of the vehicles – driving on sight, so to speak. You can switch the basic functions and change the speed without having to
connect the vehicle to its programming device, item 8401. The key assignment is listed below:
Key
Function
Switches the vehicle off
(Switch on with integrated permanent magnet)
When the key is pushed, the connection to the ve-
hicle is confirmed by the illumination of the cabin
light and the rotating beacons
Accelerate (in 10 km/h intervals)
Brake (in 10 km/h intervals)
The vehicle stops and, after a short delay, it drives
backwards as long as the button is held down
By pushing this key, the vehicle starts off
Display for battery charging level
You can switch the vehicle on and off magnetically with the remote control, item 8402 (fig. 2) or optionally switch it off with the
red button of the remote control.
Key
Function
Direction indicator left
Direction indicator right
Switching of main lights
Switching of high beam
Switching of rotating beacons
Switching of warning lights
EN
3
Werbung
