Battery Charge Indicator - Bosch Intuvia 100 Originalbetriebsanleitung

Operation
Connection of the On-Board Computer with the
eBike System (Pairing)
Your on-board computer is generally already connected with
the eBike system. If this is not the case, proceed as follows:
– Install the eBike Flow app.
– Activate Bluetooth® on your smartphone and open the
eBike Flow app.
– Briefly press the Bluetooth® button.
– The device identification is shown on the display.
– Select the required tool with the same identification in
the eBike Flow app.
You can find further information at the following link:
https://www.bosch-ebike.com/de/help-center/intuvia-100.
Depending on the smartphone's operating sys-
tem, the eBike Flow app can be downloaded
free of charge from the Apple App Store and
the Google Play store.
Use your smartphone to scan the code in order to download
the eBike Flow app.
Switching the on-board computer on/off
Switch on the eBike system.
To switch on the on-board computer, gently move the eBike
or tap the display.
The following options are available for switching off the on-
board computer:
– Press the ON/OFF button on the operating unit to switch
off the eBike system.
The on-board computer is also switched off.
– Remove the on-board computer from its holder.
The on-board computer switches off automatically after
60 seconds.
Power supply for the on-board computer
The on-board computer is provided with energy by the
CR2450 coin cell.
Changing the non-rechargeable battery
(see figure C)
When the non-rechargeable battery of the on-board com-
puter is nearly drained, you're shown a corresponding mes-
sage on the display. Open the battery compartment
cover (2) with a slotted screwdriver (12), remove the used
non-rechargeable battery and insert a new non-rechargeable
battery of type CR2450. You can obtain the non-re-
chargeable batteries recommended by Bosch from your bi-
cycle dealer.
When inserting the non-rechargeable battery, ensure that
the rubber seal (10) is correctly positioned.
Seal the battery compartment and slide the on-board com-
puter onto the holder.
Bosch eBike Systems

Battery charge indicator

The on-board computer shows the state of charge of the
eBike rechargeable battery in per cent. A notification is dis-
played once when the battery's state of charge falls below
30%, and again when it falls below 10%. The notification can
be confirmed, or it simply disappears after 5 s.
Operation
The Bluetooth® (1) button has various functions. If the on-
board computer was connected with an operating unit and
has been removed from the holder, the displays can be
switched within 60 s. To do so, briefly press the Bluetooth®
(1) button.
Note: If you are not going to be using your eBike for several
weeks, remove the on-board computer from its holder and
set the on-board computer to storage mode. To do so, press
the Bluetooth® (1) button for 8–11 s.
The reset button (5) serves to reset the on-board computer
to factory settings and delete all connections.
The on-board computer can be operated and the indicators
can be controlled via one of the depicted operating units.
The meaning of the buttons on the operating units for the
display indicators can be found in the following overview.
Depending on how long it is pressed for, the select button
has 2 functions.
LED Remote
Mini Remote
Scroll left (only for LED Remote)
English – 3
0 275 007 3BI | (24.03.2022)