Wing Installation - Horizon Hobby hobbyzone Apprentice S 2 1.2m Bedienungsanleitung

EN

Wing Installation

We recommend watching the "Wing Installation"
chapter/section of the assembly video by
scanning this QR code or using this URL:
www.horizonhobby.cc/ApprenticeS2assembly.
The wing of the Apprentice S 2 1.2m is secured to the fuselage using four
of the included rubber bands. This method of installation allows the wing to
move or separate from the fuselage in the event of a hard landing or crash,
minimizing damage to the airframe. The use of more than four rubber bands is
not recommended, as using additional bands may cause the wing to be held
too securely to the fuselage.
1. Connect the aileron servo connectors to the Y-harness, marked "AIL", in
the fuselage. The left and right servos can be connected to either side of
the Y-harness. Ensure the Y-harness is connected to port 2 of the receiver.
Correct operation of the SAFE system requires connection of both ailerons
to the included Y-harness and port 2 of the receiver.
IMPORTANT: Ensure the servo connectors and the Y-harness are connected
with the correct polarity. The connectors have a small bevel on two corners
which must align with the corresponding bevel in the Y-harness connectors.
In addition, the wire colors should match between the servos and Y-harness.
2. Center the wing on the fuselage. The bottom of the wing should sit flat
against the top of the fuselage wing saddle.
IMPORTANT: Ensure the aileron servo wires are not pinched between the
wing and fuselage.
3. Secure the wing to the fuselage by installing four rubber bands between
the front and back fuselage pins and over the top of the wing.
TIP: Install each of the first two bands diagonally, starting from the front pin
to the rear pin on the opposite side of the fuselage. Install the last two bands
starting from the front pin straight back to the rear pin on the same side of
the fuselage.
®
Assembly Video
6