Venicci TINUM SE 2.0 Bedienungsanleitung Seite 18

EN
use, that it is removed from the carrycot. Carrycots fitted with top central carrying
handle; before lifting ensure that the handle is positioned perpendicularly to the
carrycot, and the lock in its base are turned on and working properly.
For any warranty and post-warranty repairs only use the parts supplied or
»
recommended by the relevant manufacturer or distributor. The pram should not
be used if any sort of defect has been noticed or any of the elements have been
damaged.
The hood of the seat unit has been designed using flexible strips of steel, which
»
under the influence of pressure can be deformed. This may result in decreased
spacing between the internal metal bars and other parts of the system and lead to
damage such as causing fabric to tear. ln the case of deformation you must make a
correction by gently squeezing, stretching the internal metal bars.
ln the case of travel systems fitted with reversible seat unit, it is not allowed to
»
change its position while baby is in it.
After unfolding the chassis, check whether the front and rear wheels are fitted
»
properly by trying to detach them from the chassis without pressing the button that
unlocks the locking mechanism.
'D' rings are provided for the attachment of an additional harness. These are located
»
on the existing harness close to where it is attached to the seat frame. 'D' rings are
provided for fitting a separate harness if required. Replacement Harness can be
purchased directly from distributor.
Operating the parking brake.Press down on the pedal to engage the parking brake.
»
Press down and release to disengage the parking brake. WARNING: Never leave the
vehicle without first fully engaging the parking brake.
18