2.1 Sound System
9. OPERATION
This section introduces the basic operation of the 2.1 Sound System.
All settings can be conveniently carried out with the remote control. The basic func-
tions can also be carried out with the buttons on the device. Operation of the device in
the instructions is usually described with the remote control.
9.1
SWITCHING ON AND OFF WITH THE POWER SWITCH
After the soundbar is connected to the power supply, the device switches itself to pow-
er saving mode (standby mode).
•
The button
to switch the soundbar to power saving mode (standby mode).
•
From power saving mode, you can switch the device on by pressing the button
It is in the mode most recently selected.
•
To disconnect the device from the mains, pull the mains plug out of the power
socket.
NOTE: if the device does not receive a signal for approx. 15 minutes, it automatically
switches itself to standby mode.
9.2
ACCESSING SOURCES
In order to switch to the different sound sources, use the remote control or the
ton on the device.
Sound source
connected via
HDMI ARC
OPTICAL
COAXIAL
AUX
Bluetooth
connection
•
Press the
button on the device repeatedly until the corresponding LED is lit/
flashes.
CUSTOMER SERVICE
00800 - 456 22 000
on the remote control or the button
Press on the
remote control
HDMI
OPTICAL
COAX
AUX
BT
on the device can be used
LED
lights up in white
lights up in orange
lights up in purple
lights up in green
•
Connection established: lights
up in blue
•
Searching for connection: flash-
ing in blue
www.gt-support.de
Operation
.
but-
55