Optical Connection - AudioAffairs CCX 010 Bedienungsanleitung

2.1 Sound System
1. Check ...
... whether the external device has an HDMI ARC input.
... whether the ARC function can be used permanently on all HDMI connections
on the external device or if the ARC function must be switched on first. Please
refer to the manual of the external device.
2. If necessary, switch on the ARC function on the menu of the external device.
3. Use an HDMI cable to connect the HDMI ARC output of the external device to the
HDMI ARC socket.
4. Press the button to turn on the 2.1 Sound System, and also turn on the external
device.
5. For the playback press the HDMI ARC button on the remote control of the
2.1 Sound System. The LED lights up in white.
6. Then start playback on the external device. If the connection is correct, you can
now control the sound of the 2.1 Sound System via the television remote control.
NOTE: if you do not hear any sound from the 2.1 Sound System after a few seconds, set
the audio output to PCM on the menu of the television.
7.2

OPTICAL CONNECTION

To connect external devices to the OPTICAL socket, you need a TOSLINK cable. The ca-
ble is not included in the scope of supply.
1. Pull the protective cap out of the OPTICAL socket and remove any protective cap
from the plugs of the TOSLINK cable.
2. Use a TOSLINK cable to connect the optical output of the external device with the
OPTICAL socket.
3. Press the button to turn on the 2.1 Sound System, and also turn on the external
device.
CUSTOMER SERVICE
00800 - 456 22 000
Connecting external devices
www.gt-support.de
51