Removing Nose And Ear Hair; Cutting Eyebrows - Silvercrest Z31635 Bedienungs- Und Sicherheitshinweise

Removing nose and ear hair

Note: Do not use the product if the blade
Take off the protective cap
ON / OFF switch
Carefully insert only the tip of the blade into the front area of your nos-
tril or ear. Remove the nose or ear hair with small circular movements.
After using the trimmer, switch the device off by pushing the ON / OFF
switch downwards.

Cutting eyebrows

Select the long comb attachment
depending on the desired hair length ("Long"
length; "short"
Set the comb attachment on the blade (see fig. C). Ensure that the
comb attachment
Switch the appliance on. Move the comb in the opposite direction to
the hair growth, and from the outer tip of the eyebrow towards the
nose (see Fig. D).
To trim hair just above the skin surface, remove the comb attachment
and guide the blade
7
Note: To trim only individual hairs, adjust the angle of the blade and
guide this against the individual hairs.
. Switch the device on by pushing the
1
upwards.
3
: approx. 4 mm length).
7
, fastens audibly and sits tightly.
6 7
directly over the skin in the desired area.
2
is deformed or damaged.
2
or the short comb attachment
6
: approx. 7 mm
6
7
,
6
GB/IE 13