Herunterladen Inhalt Inhalt Diese Seite drucken

Standby Power; Connections To A Building's Electrical System; System Ground; Special Requirements - CGM DUAL15000SP Benutzerhandbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 145
OPERATION
The total power requirements (VA) of all appliances connected must be considered. Appliance and power tool manufacturers
usually list rating information near the model number or serial number.

STANDBY POWER

Connections to a Building's Electrical System

Your generator can supply power to a building's electrical system. If the generator will be used as an alternative to utility
company power, an isolation switch must be installed to disconnect the utility lines from the building when the generator is
connected. Installation must be performed by a qualified electrician and must comply with all applicable laws and electrical
codes.
In some areas, generators are required by law to be registered with local utility companies. Check local regulations for proper
registration and use procedures.

System Ground

These generators have a system ground that connects the generator frame components to the ground terminals in the AC
output receptacles. The system ground is not connected to the AC neutral wire. If the generator is tested with a receptacle
tester, it will not show the same ground circuit condition as for a home receptacle.

Special Requirements

In some areas, generators are required to be registered with local utility companies.
If the generator is used at a construction site, there may be additional regulations that must be observed.
51

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für CGM DUAL15000SP

Diese Anleitung auch für:

Dual20000sp

Inhaltsverzeichnis